APPENDIX AVI212 Manual de usuario descargar pdf (Pagina 7)

INSTALLATION

-4-

3. INSTALLATION

3.1 Install the Hardware

This camera can be installed in two ways: ceiling-mounted and desktop. During the installation, please make sure the

upper side of the camera is always facing up, as shown in Figure 1 below, regardless of which installation way you’re using.

This is to ensure the video output won’t be up side down.

Note: The illustrations below are based on the ceiling-mounted installation.

Note: For the detailed cable connection, please refer to the section “2.1 Rear Panel” at page 3.

Tool needed: Power drill x 1 (not supplied within the sales package)

1. Prepare all the parts needed for camera installation.

Find the network camera, bracket package, a bag of screws & wall plugs, and a cap supplied with the sales

package, as shown in Figure 1.

Unpack the bracket package to find the bracket disassembled into three parts: the base, stem and joint lock.

Figure 1: Parts needed for camera installation

2. Fix the base of the bracket.

Fix the base of the bracket with the supplied 3

screws to the place you want to install by using a

power drill.

Figure 2: Screw the base to the ceiling

1 2 3 4 5 6 7 8 9 10 11 12 ... 37 38

Sin comentarios

APPENDIX AVI212 Manual de usuario Pagina 7